Brand New Aqua-PlusLG FRIDGE WATER FILTER LT1000P, ADQ74793503, 74793501 and 74793506fridge water filter used in LG Fridges.

Features:

Reduction filter works by chemical and mechanical means

LG Fridge FilterLT1000P LT1000PC LT1000PCS ADQ7479350174793501 and 74793506

Delivers clean, clear water for great tasting up to 97%

Effectively reduce cysts, chlorine taste and bad odour(99% of lead, 99% of Mercury, over 99% cysts, over 99% asbestos, 93%ofToxaphene, 77% Altrazine, 99% Lindane, 97% Chlorine and 99%, rust, sand, dirtand sediment.)

Tested and used material according NSF International against NSF/ANSI Standards 42 for the reduction of chlorine taste and odour.

?In order to keep your filter working at its optimum, fridge manufacturers generally recommend replacement of fridge water filters every 6 months, or when the "change filter" light comes on or notice a decrease in flow of water..

The LT1000Prefrigerator/icemaker water filter is compatible with the following refrigerators:
GF-D708BSL
GF-D708MBSL
GF-L570MBL
GF-L570PL
GF-L708PL
GF-V570MBL
GF-V708BSL
GF-V708MBSL
GF-V910MBSL

LFXC24796D
LFXC24796S
LFXS30796D
LFXS30796S
LMXC23796D
LMXC23796S
LMXS30796D
LMXS30796S
LSFXC2496D
LSXC22396D
LSXC22396S
LSXS26396S
SG-5I700TSL
LG Fridge Water Filter Spec:
Filter Type: Activated Carbon Block Filter Capacity: 200gallons / 757liters
Flow Rate: 0.5gallon / minute
Operating Temperature: 33 - 100 Fahrenheit
Operating Pressure: 30-120 PSI
Micron Rating: 0.5
Installation and replacement procedure for the LG LT1000P / ADQ74793503 fridge water filter:
1. Remove the top shelf.
If the top shelf, which is located below the water filter, is in the highest position, it will need to be removed. This can be done in two simple steps:
- Tilt up the front of the shelf and lift it.
- Pull the shelf out.

2. Remove old water filter.
Pull the old water filter downward and turn it counter-clockwise to pull it out.
Make sure to rotate the filter down completely before pulling it out of the manifold hole.

3. Install new water filter.
Take a new water filter out of its packaging and remove the protective cover from the o-rings.
With the filter tabs in the horizontal position, push the new filter into the manifold hole, rotate it up into place, and close the cover.

4. Remove trapped air.
Now that the filter is replaced, dispense 2.5 gallons of water to remove trapped air and contaminants from the system.
Depress and release the dispenser pad for cycles of 30 seconds ON and 60 seconds OFF, rather then dispensing continuously.

If your model is equipped with a water filter indicator on the display, press and hold the FILTER button
or RESET button for approximately 5 seconds to reset the filter indicator.